Ⅰ. Auxiliary equipment of double screw extruder machine1. Straightening device. During the extrusion of the sheath, the scratches on the surface of the sheath are caused by the bending of the cable c...
Ⅰ. The principle of the unstable end base of the two-screw extruderIn the production process of FEP, because the initiator used in the aqueous phase polymerization reaction system is a persulfate suc...
1. Check the dual-screw extruder barrel, the top and bottom of the hopper, and whether there are foreign objects before starting each time, check whether the fastening bolts of each part are loose, wh...
The dual-screw extruder adopts helical gear or hard-tooth surface gear reducer, which has stable transmission, long sound and long service life. The shaft seal has advanced structure and good sealing ...
In the process of producing products with double-screw extruders, not only should the quality of the products be guaranteed by adjusting the machine, but also the safety of the operators should be giv...
Ⅰ. Operation instructions of the screw sleeve of the double-screw extruder:1. Before each threading, the chips in the die chip flute and in the thread should be cleaned up;2. Check the diameter of th...
When we use the double-screw extruder, we will inevitably encounter the phenomenon of machine failure. If the machine fails, then we must learn to analyze these failures, and only after analysis can h...
The double-screw extruder is developed on the basis of the single-screw extruder. Due to its good feeding performance, mixing and plasticizing performance, exhaust performance, extrusion stability and...
When operating a double screw extruder. We must grasp the control of the machine in place, do not use the wrong operation method, or do not stop the machine in the correct way. If the stop sequence is...
Tel: +86-25-52706155
E-mail: info@kymach.com
No.59 West Tianyuan Road, Jiangning, Nanjing, Jiangsu Province, China
English 
日本語 
한국어 
français 
Español 
русский 
português 
العربية 
中文
